-
×
MPU-6050 3-Axis Accelerometer and Gyro Sensor
1 × ₹159.00
Subtotal: ₹159.00
ACCELEROMETER & GYROSCOPE
Showing all 3 results
-
ACCELEROMETER & GYROSCOPE, SENSOR AND MODULES
ADXL335 Module 3-axis Analog Output Accelerometer
Features :
- Onboard LDO Voltage regulator
- Can be interfaced with a 3V3 or 5V Microcontroller.
- All necessary Components are populated.
- Ultra-Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
- Tap/Double Tap Detection
- Free-Fall Detection
Operating Temperature (°C) -40 to 90 Length (mm) 21 Width (mm) 16 Height (mm) 2.5 Weight (gm) 0.6 - Analog output
- Build-in ultra-low noise linear LDO voltage regulator
- Built-in onboard filters, which reduce noise from the motor and other high current electronics
- Power LED
- Designed for 5V logic level
SKU: n/a -
ACCELEROMETER & GYROSCOPE, SENSOR AND MODULES
ADXL345 Tripple Axis Accelerometer Board
Features :
- Ultra-Low Power: 40µA in measurement mode, 0.1µA in standby@ 2.5V.
- Free-Fall Detection.
- Tap/Double Tap Detection.
- Flexible interrupt modes mappable to either interrupt pin Measurement ranges selectable via serial command Bandwidth selectable via serial command
- Wide temperature range (−40°C to +85°C).
- 10,000 g shock survival.
- Support 5V/3.3V voltage input, onboard RT9161 power chip, lower pressure drop faster than 1117, the faster load speed of response, very suitable for high-noise power supply environment.
- User-selectable resolution
- Fixed 10-bit resolution.
- Full resolution, where resolution increases with G range, up to 13-bit resolution at ±16 g (maintaining 4 mg/LSB scale factor in all G ranges).
-
Input Supply Voltage (VDC) 3.3 ~ 5 Interface Type I²C, SPI Sensing Range ±2g, ±4g, ±8g, ±16g X-Axis Sensitivity 28.6 LSB/g Y-Axis Sensitivity 31.2 LSB/g Z-Axis Sensitivity 34.5 LSB/g Length (mm) 20.5 Width (mm) 15.5 Height (mm) 3.5 Weight (gm) 0.6
SKU: n/a -
ACCELEROMETER & GYROSCOPE, SENSOR AND MODULES
MPU-6050 3-Axis Accelerometer and Gyro Sensor
Features :
- Chip built-in 16bit AD converter, 16-bit data output.
- I2C Digital-output of 6 or 9-axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format.
- Selectable Solder Jumpers on CLK, FSYNC, and AD0.
- Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization, and gesture detection.
- Embedded algorithms for run-time bias and compass calibration. No user intervention is required.
- Digital-output temperature sensor.
Driver IC MPU-6050 Operating Voltage (VDC) 3 ~ 5 Communication I2C Protocol Gyro range(°/s) ± 250, 500, 1000, 2000 Acceleration range(g) ± 2 ± 4 ± 8 ± 16 Length (mm) 20 Width (mm) 16 SKU: n/a
